|
propane sensor 14 messages
After all the smoke from the fires, we hear a beep in our 2015 View G. We found that the propane sensor was flashing red and green. We pushed the button and it went to green and no more beeping. We th
After all the smoke from the fires, we hear a beep in our 2015 View G. We found that the propane sensor was flashing red and green. We pushed the button and it went to green and no more beeping. We th
|
By Mary
·
|
|
Turning front wheel simulators into wall art.
I read all the horror stories about simulators falling off and pulling valve stems off or just causing stems to wear through causing catastrophic blow outs. So, not wanting to refi the house to buy al
I read all the horror stories about simulators falling off and pulling valve stems off or just causing stems to wear through causing catastrophic blow outs. So, not wanting to refi the house to buy al
|
By Stephen Dasaro
·
|
|
Group guidelines reminder
Please read https://view-naviontech.groups.io/g/discussion/guidelines Thanks, Bob -- 17NJ Santa Fe, NM
Please read https://view-naviontech.groups.io/g/discussion/guidelines Thanks, Bob -- 17NJ Santa Fe, NM
|
By Bob Knight
·
|
|
HWH not working on electric/propane 2 messages
I just returned from a two day short RV trip to change the scenery. On the first night I turned on the electric to HWH. After dinner we did not have any hot water for dishes despite 1-2 hours of waiti
I just returned from a two day short RV trip to change the scenery. On the first night I turned on the electric to HWH. After dinner we did not have any hot water for dishes despite 1-2 hours of waiti
|
By Karin Kirchhoff
·
|
|
house door latch 6 messages
Roger, Since you mentioned it, do you know of a way to adjust the two stage house door latch? I have to slam my door to get it to second stage where it is fully latched and closed. When it was new I c
Roger, Since you mentioned it, do you know of a way to adjust the two stage house door latch? I have to slam my door to get it to second stage where it is fully latched and closed. When it was new I c
|
By stenor
·
|
|
LP Emergency Shut Off Flip Switch - Ideas Wanted
While cleaning our 2012J last time I noticed the rocker switch cover had come off the outside LP Emergency Shut Off. I am wondering if any member has experience with this? Is the 'cover only' availabl
While cleaning our 2012J last time I noticed the rocker switch cover had come off the outside LP Emergency Shut Off. I am wondering if any member has experience with this? Is the 'cover only' availabl
|
By MichiganView
·
|
|
Electric Wiring Schmatic 3 messages
Help! Two questions: Does anyone have, or know how to get, an electrical schematic for the Navion View 24j, 2018. OR Can someone tell me how to trace wiring on the diagrams available on the Winnebago
Help! Two questions: Does anyone have, or know how to get, an electrical schematic for the Navion View 24j, 2018. OR Can someone tell me how to trace wiring on the diagrams available on the Winnebago
|
By Kenneth Markel
·
|
|
Wiring Diagrams
Here’s a full set of wiring diagrams for the 18 J that I obtained from Winnebago. They are very helpful and will send you about anything you want. Jerry K 360-509-8861 Begin forwarded message: From: W
Here’s a full set of wiring diagrams for the 18 J that I obtained from Winnebago. They are very helpful and will send you about anything you want. Jerry K 360-509-8861 Begin forwarded message: From: W
|
By Jerry Knowles
·
|
|
Cargo Door Latch Does Not Hold 4 messages
I found that the large cargo door (underneath the bed on the J model) did not latch at all. I took what I could apart, lubed it and got the mechanism in the picture to "catch". But it does not hold. I
I found that the large cargo door (underneath the bed on the J model) did not latch at all. I took what I could apart, lubed it and got the mechanism in the picture to "catch". But it does not hold. I
|
By Jim Poulin
·
|
|
Cargo Door Latch Does Not Hold - Resolved!
Thanks for all the replies. I went in and manually pulled the lever to get the latch to catch using an allen key as a pulling lever via the plug hole. I then applied lubricant liberally from both the
Thanks for all the replies. I went in and manually pulled the lever to get the latch to catch using an allen key as a pulling lever via the plug hole. I then applied lubricant liberally from both the
|
By Jim Poulin
·
|
|
Belt failure 18 messages
serpentine belt issues
By
MIKE BAGLEY
·
|
|
Norcold Error Code 13 8 messages
Just went to start up the refrigerator for the next trip and I'm getting error code 13 flashing on the refrigerator panel. I did talk to a tech that said the circuit board needs to be reset. Has anyon
Just went to start up the refrigerator for the next trip and I'm getting error code 13 flashing on the refrigerator panel. I did talk to a tech that said the circuit board needs to be reset. Has anyon
|
By Pete S
·
|
|
Wave 6 15 messages
Hi all, I am intrigued by the Wave 6 comments. I am in a 2016 View. I am out mostly in the winter and have had lots of cold nights: down as low as 22-25 degrees F overnight. I have not kept the furnac
Hi all, I am intrigued by the Wave 6 comments. I am in a 2016 View. I am out mostly in the winter and have had lots of cold nights: down as low as 22-25 degrees F overnight. I have not kept the furnac
|
By Dick Stevenson
·
|
|
new batteries for a 2016 View 30 messages
Hi all, Casual figuring from rough measurements when I was near my rig, seem to suggest that I could fit 2 Lifeline AGMs, GPL 27T (13.09 x 6.6 x 9.25 inches) into the existing battery compartment unde
Hi all, Casual figuring from rough measurements when I was near my rig, seem to suggest that I could fit 2 Lifeline AGMs, GPL 27T (13.09 x 6.6 x 9.25 inches) into the existing battery compartment unde
|
By Dick Stevenson
·
|
|
Inverter Stopped working 7 messages
Out camping this last week and tried to use my inverter to make toaster to make toast, but the inverter stopped working. Checked the inverter underneath in the cabinet. It appears that the GFCI is tri
Out camping this last week and tried to use my inverter to make toaster to make toast, but the inverter stopped working. Checked the inverter underneath in the cabinet. It appears that the GFCI is tri
|
By Jerry Knowles
·
|
|
Power to the Chassis radio -
The rocker switch below the radio is labeled "Radio Power" and can be set to "Engine" or "House". This lets us choose to power the radio from either the Mercedes battery in the chassis, or the house b
The rocker switch below the radio is labeled "Radio Power" and can be set to "Engine" or "House". This lets us choose to power the radio from either the Mercedes battery in the chassis, or the house b
|
By CHARLES E
·
|
|
King Jack antenna problem 2 messages
My antenna will not turn when rotating the knob. The knob will now turn all the way around with not stop. I removed the knob and I thought maybe I would find some broken part, but no. I looked on line
My antenna will not turn when rotating the knob. The knob will now turn all the way around with not stop. I removed the knob and I thought maybe I would find some broken part, but no. I looked on line
|
By paisleydale
·
|
|
Service near Bryce canyon 6 messages
I've had the dreaded check engine light come on and my reader tells me it has something to do with a NOx sensor. Does anyone know of a service provider in my area of southern Utah period after this we
I've had the dreaded check engine light come on and my reader tells me it has something to do with a NOx sensor. Does anyone know of a service provider in my area of southern Utah period after this we
|
By Charles Stewart
·
|
|
Cell booster 35 messages
I’m considering the purchase of a we boost cell phone signal booster. Is anyone using one or recommendation for a different one? We have T-mobile and consumer cellular. Thinking I don’t need a wifi bo
I’m considering the purchase of a we boost cell phone signal booster. Is anyone using one or recommendation for a different one? We have T-mobile and consumer cellular. Thinking I don’t need a wifi bo
|
By John8392@...
·
|
|
Serpentine belt problems
Protecting transmission cooling hose from belt failure
Protecting transmission cooling hose from belt failure
|
By
MIKE BAGLEY
·
|